TAKING CARE OF YOUR NEW ROPES

We take great care in manufacturing the highest quality rope. A few guidelines about its general use will help you to increase the life of the rope and assist you in achieving the best performance from our products.

Abrasion and Sharp Edges

Abrasion and sharp edges are a rope’s worst enemy. Check all surface a rope may come in contact with to make sure there are no burrs or sharp edges. All cotter pins and split rings in turnbuckles and blocks should be taped.

Dirt and Cleaning

Dirt and salt can cause premature wear. Wash rope and rigging with fresh water as needed. For a thorough cleaning, soak your ropes in warm water with a mild detergent. Add a little fabric softener to make them soft. Rinse thoroughly and then hang them up to dry.

Sheave Diameter

As a rule of thumb, the diameter of any sheave should be at least eight times the diameter of the rope (for 3/8” rope, use 3” sheave). The sheave groove should be a gentle curve, not a “V” or double groove (as used with wire rigging). The groove should also be approximately 10% wider than the rope.

Rope Longevity and Eliminating Twist

The process of wrapping line around winches, windlasses and cleats puts a tremendous amount of twist into a rope. The twist makes the rope hard to handle and more prone to kinking or jamming in blocks. Severe twist will cause the rope to get out of round, resulting in faster wear and reduced strength. To eliminate twist, let rope hang free at both ends. Store by flaking into a rope back or hank in a figure 8 fashion.

Safety

Snapback: An extremely hazardous situation can be created if a rope parts under heavy loads. The rope will recoil (or “snapback”) at a high rate of speed. A person positioned in the rope’s path could be seriously injured. It is the responsibility of the user to know and understand the proper technique for the particular application and to take all necessary precautions.

Chemicals: Synthetic fibers have resistance to most chemicals. However, exposure to harsh chemicals, such as acids and alkalis, should be avoided.

Damage: Inspect all ropes frequently for signs of wear or damage. Retire any rope that is cut or abraded.

Sunlight: With time, all synthetic fibers will undergo degradation when exposed to sunlight. Polypropylene is more susceptible to UV degradation than other fibers.

Tensile Strength

The tensile strength is the load at which a new rope, tested under laboratory conditions, can be expected to break. Rope strength shown in our literature is the approximate average for new rope tested under ASTM test method D-6268. To estimate the minimum tensile strength of a new rope, reduce the approximate average by 20%. Age, use and the type of termination used, such as knots, will lower tensile strengths significantly.

Working Loads

The Cordage Institute specifies that the safe working load of a rope is determined by dividing the minimum tensile strength by the safety factor. Safety factors range from 5 to 12 for non-critical uses. The working load is a guideline for rope in good condition used in non-critical applications, and should be reduced where life, limb, or valuable property are involved, or where exceptional shock, sustained loading, severe vibration, etc. may be experienced.

Print Friendly, PDF & Email